DUOYI dy3015c 12V/24V Car Battery Tester with Printer Automotive Battery

12V/24V Car Battery Tester 

 

 

Please Note

• 【QUICK TEST】This battery tester automotive is a more advanced tool with the capability to test automotive, marine, motorcycle, Electric car battery and UPS batteries. Four Intelligent tester fully diagnose battery status and electrical systerm of the car
• 【TESTING STANDARDS】This battery tester for cars and system analyzer can test 12V lead-acid batteries and has a wide applicability to regular flooded, AGM flat plate, AGM spiral, gel and deep-cycle batteries. It covers all battery rating Standards such as CCA, JIS, DIN, IEC, EN standards.
• 【HIGH DESIGN】Universal battery tester with printer fast and accurate, displaying battery parameters in about 2 seconds to advise you of a battery's full/low or charge/replace status.The unit is housed in rugged casing for easy hand-holding. It's lightweight and has a backlit display screen for clear reading under any lighting condition.
• 【BUILT IN PRINTER】Its built-in printer uses standard thermal printer paper, so you can conveniently attach a printout to a work order, share it with your customers or build a preventative maintenance program of record.
• 【EASY TO USE】Help you diagnostic and solve your car health problem timely without disconnecting the battery(or on separate battery). Avoid the accident may happen caused by car itself.DUOYI 3015C battery tester can detect common faults of both starting and generator charging systems, which helps you achieve quick repair to the vehicle problems, Save you money and time. Intergrated printer makes it more practical.

Quick Result

It's fast and accurate, displaying battery parameters in about 2 seconds to advise you of a battery's full/low or charge/replace status.The unit is housed in rugged casing for easy hand-holding. It's lightweight and has a backlit display screen for clear reading under any lighting condition.

 

BATTERY TESTER

• Fast measurement

After starting the power, adjust the reference standard value according to the actual condition of the nameplate on the battery, select the quick test, and the test area will display the test result.

• Accurate measurement

After starting the power, according to the actual condition of the nameplate on the battery, compare the battery standard as the test standard, adjust the matching value of the corresponding battery to select the accurate test, that is the result.

The internal resistance standard will vary depending on the battery made by different manufacturers using different materials. Therefore there is no standard. However, the same type of battery of the same manufacturer, the internal resistance value will not differ greatly from the factory. The larger the CCA value of the battery, the smaller the internal resistance will generally be.

 

STARTER SYSTEM STAR-UP LOAD TEST

Start-up load test instruction

★the lowest voltage higher than 9.6V(for 24V system, the reading is over 16V) means the start-up load sys tem is good.

★the lowest voltage lower than 9.6V (for 24V system, the reading is below 16V) means the system need to check. Please check the relative connections, wire and engine. Also the terminals of the battery should be checked if rusted.

 

MAXIMUM LOAD SYSTEM TEST

Charging system test

★If the voltage is higher than 15.00V (for 24V system, the reading is over 30.00V), please check the voltage regulator.

★Ifthe voltage is lower than 13.30V (for 24V system, the reading is under 26.60V), please check the connections, wires and theengine.

The above data is for reference only, the result can be affected by the defective battery.

 

Parameter